{{ pageTitle }}
{{ pageIntro }}
{{ p.numContent }}
{{ p.label }}
Connect your imaging system
Tell us about the system that will send and receive images. Your PACS or an imaging device.
Loading your saved configuration…
We couldn't load your saved configuration
Nothing has been changed. Try again rather than entering the details fresh, which could save a second configuration beside the one you already have.
Open this page from your dashboard
We couldn't find your account on this device, so there is nothing to load and nowhere to save. Sign in, then choose Configure gateway from your dashboard.
This is the imaging system saved to your account. Choose Edit to change it.
Saved, but not yet reachable
Your imaging system was saved, but publishing its route failed, so partners cannot reach it yet. Save again, or contact support if it keeps happening.
{{ saveErr }}
{{ sumHead }}
{{ sumList }}
{{ errType }}
{{ errSysName }}
{{ errDestAe }}
The DICOM application entity title your imaging system answers to. Up to 16 characters. Usually set by whoever installed it.
{{ errHost }}
{{ errPort }}
MedwebX complements your current image sharing. It doesn't replace it.
The Terms and Conditions were accepted during registration, so there is nothing to sign here.
Choose your operating system
{{ osNote }}
{{ dlPhase }}
Your gateway comes pre-configured for this system. Your download is unique to you.
How installation works
1Pick the computer. Install on a workstation on the same network as your imaging system, one that stays powered on and online.
2Get the installer onto it. Download here if you're on that computer now, or copy your link and sign in there.
3Run it and you're connected. The installer signs in automatically, with nothing to type.
{{ bannerHead }}
{{ bannerBody }}
{{ dlErr }}
Choose your operating system
{{ osNote }}
{{ dlPhase }}
Download your gateway
Already configured for your imaging system. Download it any time to install or set it up on another workstation.
Choose your operating system
{{ osNote }}
{{ dlPhase }}
Open it on the workstation and sign in to download
Your browser blocked copying. The link is selected below, copy it with your keyboard.
{{ copyUrl }}
How installation works
1Pick the computer. Install on a workstation on the same network as your imaging system, one that stays powered on and online.
2Get the installer onto it. Download here if you're on that computer now, or use Copy link to open it on that workstation.
3Run it and you're connected. The installer signs in automatically, with nothing to type.
Invite exchange partners
{{ slotLine }}Invite the facilities and colleagues you exchange with most. Partners who accept join the list below and exchange images with you automatically and securely.
Email *
{{ r.err }}
Add at least one email address
{{ inviteMsg }}
Partners you routinely exchange medical images with. Use each partner's sending address in your imaging system. No changes to your own setup needed.
Partner
Status
Sending address
{{ p.name }}
{{ p.pillLabel }}
Your browser blocked copying. The address is selected, copy it with your keyboard.
Sharing permissions
Choose what you and {{ p.name }} exchange automatically. You can change these any time.
No partners yet. Invite your first exchange partner above.
{{ tipText }}